Genesis Microchip Publication
PRELIMINARY DATA SHEET
gm5115/gm5115-H
gm5125/gm5125-H
OnPanel LCD Panel Controller
*** Genesis Microchip Confidential ***
NOTE: Sections in this data sheet that mention HDCP apply only to the HDCP-enabled chip
versions (gm5115-H and gm5125-H). All other sections apply to all chip versions (gm5115,
gm5115-H, gm5125, and gm5125-H).
Publication number: C5115-DAT-01H
Publication date: June 2002
Genesis Microchip Inc.
2150 Gold Street, Alviso, P.O. Box 2150, CA USA 95002 Tel: (408) 262-6599 Fax: (408) 262-6365
165 Commerce Valley Dr. West, Thornhill, ON Canada L3T 7V8 Tel: (905) 889-5400 Fax: (905) 889-5422
1096, 12thA Main, Hal II Stage, Indira Nagar, Bangalore-560 008, India, Tel: (91)-80-526-3878, Fax: (91)-80-529-6245
4F, No. 24, Ln 123, Sec 6, Min-Chuan E. Rd., Taipei, Taiwan, ROC Tel: 886-2-2791-0118 Fax: 886-2-2791-0196
143-37 Hyundai Tower, #902, Samsung-dong, Kangnam-gu, Seoul, Korea 135-090 Tel 82-2-553-5693 Fax 82-2-552-4942
Rm2614-2618 Shenzhen Office Tower, 6007 Shennan Blvd, 518040, Shenzhen, Guandong, P.R.C., Tel (0755)386-0101, Fax (0755)386-7874
2-9-5 Higashigotanda, Shinagawa-ku, Tokyo, 141-0022, Japan, Tel 81-3-5798-2758, Fax 81-3-5798-2759
www.genesis-microchip.com / info@genesis-microchip.com
***
Genesis Microchip Confidential ***
gm5115/25 Preliminary Data Sheet
June 2002
C5115-DAT-01H
iii
Revision History
Document
Description
Date
C5115-DAT-01A
Initial release.
March 2001
C5115-DAT-01B
In Table 18 corrected description of OSC_SEL (on pin ROM_ADDR13). It should be set to 1 to
indicate usage of a single-ended clock oscillator.
Corrected image and orientation of logo in pin out diagram Figure 2.
Added section 4.11.3.
June 2001
C5115-DAT-01C
Replaced all occurrences of CVDD with CVDD_2.5, including pin numbers 26, 88, 134 and 203
to make them consistent with the names of other 2.5V voltage supply signals.
July 2001
C5115-DAT-01D
Pin number 205 name changed from GPIO16/HFS to GPIO16/HFSn and all occurrences of
HFS replaced with HFSn to reflect the fact that this signal is active low.
Added description of 2-wire serial protocol in section 4.17.2 and Table 24.
Removed "Read with Increment" operation description.
Corrected mechanical specification in Figure 32.
Changes to Table 21 DC Characteristics:
- Maximum voltage for 5V-tolerance inputs is 5.5V.
- Added maximum current requirements.
Added description of OCM Standalone configuration Figure 26.
Added Figure 22 Panel Power Sequencing.
July 2001
C5115-DAT-01E
Added description of gm5125 (SXGA device).
Pin names changed to reflect alternate hard-wired functions:
- pin 50 from GPIO11 to GPIO11/ROM_WEn,
- pin 51 from GPIO12 to GPIO12/NVRAM_SDA,
- pin 52 from GPIO13 to GPIO13/NVRAM_SCL,
- pin 6 from DDC_SCL to GPIO14/DDC_SCL,
- pin 7 from DDC_SDA to GPIO15/DDC_SDA,
- pin 46 from GPIO6 to GPIO6/TCON_SHC,
- pin 47 from GPIO7 to GPIO7/TCON_TDIV.
Removed description of 6-wire host interface, since this is not recommended operation. Pin 1
name changed from GPIO17/HDATA0 to GPIO17, and similarly for pins 206, 207 and 208.
Corrected maximum ADC sampling frequency in Table 15 and maximum ADC_CLK frequency
in Table 22 to 162.5MHz.
Added section 4.5 Test Pattern Generator.
Added description of TCON_SHC and TCON_TDIV in section 4.13.1.
Clarifications to section 4.1 describing clock generation, section 4.7.2 describing sRGB support,
and section 4.15.3 describing GPIOs.
Removed mention of row attributes in Figure 25.
gm5115/25 OSD controller does not have row attributes.
Corrected Table 21, Note 3. Pins VDD1_ADC_2.5, VDD2_ADC_2.5, VDD_RX0_2.5,
VDD_RX1_2.5 and VDD_RX2_2.5 are digital 2.5V supplies, not analog.
Changed signal names SCL and SDA to HCLK and HFSn, respectively in Figure 29, Figure 30,
and Figure 31.
August 2001
C5115-DAT-01F
Added note on Front Cover regarding HDCP enabled versions.
Added section 4.12 - Energy Spectrum Management (ESM).
Added clarification in section 4.13.1 indicating that single bus configurations are supported in
XGA column drivers only.
In section 4.16, clarified that ROM_ADDR[15:0] have internal 60K pull-down resistor.
Changes to Table 20 Absolute Maximum Ratings:
Renamed parameters
JA_XGA
,
JA_SXGA
,
JC_XGA
and
JC_SXGA
to
JA_5115
,
JA_5125
,
JC_5115
and
JC_5125
and revised their values.
Added note (4) regarding the maximum case temperature.
Changes to Table 21 DC Characteristics:
Renamed parameters P
5115
and P
5125
and revised their values.
Revised the values of P
LP
and I
LP
.
Renamed parameters I
5115
, I
5115_2.5_VDD
, etc.
Added note (6).
Removed the clock speed column from section 6 Ordering Information and added the ordering
information for gm5115-H and gm5125-H.
Replaced occurrences of TMDS with DVI.
Changed TCON_RCLK to TCON_ROWCLK in Figure 2 and in Table 7.
Changed RCLK to ROWCLK in 4.13.2 and in Figure 24.
October 2001
***
Genesis Microchip Confidential ***
gm5115/25 Preliminary Data Sheet
June 2002
C5115-DAT-01H
v
Related documents
Chip documents
C5115-PBR-01
Preliminary Product Brief gm5115
C5125-PBR-01
Preliminary Product Brief gm5125
C5115-APB-01
gm5115 Product Family On-chip Microcontroller (OCM) Firmware Configurations
C5115-APB-02
gm5115 Product Family Support for Standard RGB (sRGB)
C5115-TOP-01
gm5115 Theory of Operation
C5115-DSL-01
gm5115 Register Listing
C5115-DSR-01
gm5115 TCON Programming Guide
C5115-DSR-02
gm5115 Input Processing Programming Guide
C5115-APN-03
gRGB Support in gm5115 Family Products
C5115-APN-04
gm5115 Family OCM User Manual
C5115-APN-06
Energy Spectrum Management (ESM) using gm5115 family OnPanel Controllers
C5115-APN-07
gm5115 Family IBIS Models
C5115-APN-08
gm5115 Monitor Standby Power Consumption
C5115-APN-10
gm5115 Enhanced Auto-Clock Configuration
Reference design documents
B0124-GUD-01
5120RD2 Reference Design Users Guide
B0124-SCH-01
5120RD2 Reference Design Schematics
B0124-BOM-01
5120RD2 Reference Design Bill of Materials
B0124-DNF-01
5120RD2 Reference Design Layout Files
B0106-GUD-01
5115EV2 Board User Guide
B0106-SCH-01 5115EV2
Schematics
Firmware / tools documents
B0092-SWT-01
gm5115 Product Family Firmware Theory of Operation for Full Custom Configuration
B0092-SUG-01
gm5115 Product Family Firmware User Guide for Full-Custom
B0092-PRN-01
gm5115 Product Family Firmware Release Notes for Full-Custom
C5115-SUG-01
gm5115 Product Family Firmware User Guide for Standalone
C5115-PRN-01
gm5115 Product Family Firmware Release Notes for Standalone
S0006-GUD-01
G-Probe Debug Software User Guide
S0014-GUD-01
G-Wizard Software User Guide